This is my lidded project. It is about 6" by 5". I glazed it in cobalt blue and put glass in the lid but when it went through the glaze kilm the glass pushed the glaze out and over the edge and sealed the lid to the bowl :( I made the top of the lid a knob and curved the edge of the bowl to that it would stick out further than the lid itself.

This was the second bowl I made that went missing out of the kilm but I found it in the back room along with another bowl after about two weeks of not being able to find it. It is glazed in cobalt blue. It is 3" by 3.5".

This is the third bowl that I made. I curved the top over to make it unique. I gladed it with cobalt blue and then dipped half in shadow green creating the drip effect on the side of the bowl. It is about 4.5" by 5".

This is one of the unfinished bowls, made to be donated. I glazed it in a shadow green with a metallic over the top. The bowl itself is about 3.5" by 2.5" deep. It was my first bowl I m

This is my set of three. This is 4" by 3" I decited to stain a dead tree on it. I made the bottom not as wide as the top. almost like a mug without a handle.

This is my second part of my set of three. The bowl is about 9" wide and about 3" deep. I put the tree inside so that it was different from the other two. The glaze didnt stain as well as id hope.

This is my third part of my set of three. The bowl is about 8" wide and 4.5" deep. This bowl ended with a crack in the bottom becayse i made the footing too thin.

This is just a normal bowl it is about 4.5" by 5" and I glazed it in cobalt blue and then dipped the top in shadow green so that it would drip down. I think the drips add uniqueness to the plain shape of the bowl.

This is my square bowl and how it turned out the begining is down below. I used tape and glazed around it with cobalt blue. Later I added clear glaze to cober the white stripes. I also shaped it to be square. It is about 4" by 6".

 This is my vase. It is 7" by 4" this is my first vase, and I glazed it with shadow green and i put a metalic over it. It gave it a layered and unique look to it. This is my favorite project so far.

For this project I started making a bowlbut then it rolled over and I decited to bend the edges to make it unique and  useful. It is about three inches by six inched wide. I use it to hold my earings and rings. I glazed it with a cobalt blue and dipped the edges in the sandy green

This is my finished pitcher. Which is my add on project. It is 6 by 5 counting the handle. I gave it its add on by putting leaves on the top of the handle. It took me a long time to figure out how I wanted to glaze it. I put leaves on the inside and outside giving it texture and making it unique.